-
CVR CB requirements?
If possible NTSB incident, pull the CB, otherwise it is NORMAL
-
IF ED 1 fails, how is info desplayed>
Automatically on ED2
-
If primary is on ED2, how can ED2 info be displayed?
Change Display Control PANEL switch to EICAS.
-
If ECP fails, what 4 buttions remain active?
-
How is gear lowered if HYD 3 or gear circuitry fails?
- Manual release handle
- Upocks released
- Nose pulled in to place by dragassisted by HYD 2
- Mains freefall then MLG aux actuators assist
-
What temp do brakes turn white?
07
-
What temp to brakes turn RED?
15
-
Detents provided for thrust levers?
- SHUT OFF
- IDLE
- CLIMB
- TOGA
- MAX POWER
-
Indication of starter cutout?
Approx 50% N2, AUTO IGNITION & ENG START msgs extinguish
-
What powers the FADEC?
- Below 50% N2, Aircraft elect sys powers FADEC
- Above 50% N2, Alternator on acces gearbox powers
-
How many channels does each FADEC have?
2, one in command and one in standby
-
How is MCT selected?
Operating thrust lever to CLIMB detent
-
Aborted start. When must MX be notified?
- ITT exceeds 815*C
- or
- HOT ICON appears
-
Which ignition system does DC Batt Bus power?
B
-
What powers thrust reversers?
HYD 1 & 2
-
Pressing TOGA for go-around aprovides what?
- Current heading hold with 5* angle of bank
- Pitch 8*
-
Function of XFR switch on Radar Control panel?
Transfers control of display range to other side
-
When will ADG deploy?
During complete AC power failure
-
EMER FLAP swtich will extend the 700 to?
-
EMER FLAP switch will extend the 900 to?
-
MAx speed to use the EMER FLAP switch?
230 KIAS
|
|