-
Describe the steps for setting up the stall series.
STALL Setup: 5000 feet and/GW of 195.0 Kg.
- DESCENT/APPROACH checklist.
- -Brief recovery speeds
- -Bank limit to 20°
Autothrottle off/Autopilot off
PF calls “AFS OVRD OFF switches off.
-
Clean Stall Configuration and Recovery
- Power...Idle
- Flaps.....Zero
- Bank.....0 or 20 degrees
At SHAKER initiate recovery
- PF "Max Thrust, Slats Extend"
- "Heading Hold, set speed 250kts"
@Vsr
"Slats Retract"
-
Departure/Approach Stall
- PF "Slats Extend, Set Speed_____kts
- pm "Speed ____kts"
- PF "Flaps 15, Set Speed____kts
- pm "Speed ____kts"
pm preselects a heading to begin 180 turn
- PF "Set Thrust 50% N1"
- pm "Thrust Set"
PF continues in 20 degree bank maintaining alt
RECOVERY
PF "Max Thrust, heading hold, heading hold"
PF recovers to Flaps 15 speed ____kts
if requested PF cleans up to 250kts
-
Landing Stall
- PF calls "Slats extend, Set Speed____kts"
- pm says "Speed ____kts"
- PF "Flaps 15, Set Speed____kts"
- pm "Speed ____kts"
- PF "Flaps 28, Set Speed____kts"
- pm "Speed ____kts"
- PF "Gear Down, Flaps 35, Set Speed Vapp, Set Thrust 50% N1"
- pm "Thrust Set"
RECOVERY
PF "FIREWALL THRUST/HEADING HOLD"
speed above AMBER FOOT
- PF "Flaps 28"
- pm "positive rate"
- PF "Positive Rate Gear Up, Map, Nav, PROF" or "Map, Heading, PROF (Used missed approach procedures)
- PF "Select Speed 250kts" or "FMS Speed"
- pm Sets Speed 250 (pull) or FMS speed
|
|