-
Max Diff Under/Negative Pressure
-.3
-
On ER/LR aircraft equip with Fadec 7.6. Min/Max Oil Pressure > 88% N2
50 , 110
-
On XR Aircraft equip with Fadec 7.6 Min/Max Oil Pressure > 88%
48 , 110
-
Oil Pressure Amber range bet. ___&___ is permitted for ___ mins. Between ___&___ is permitted for ___mins.
- 111 & 115 for 5
- 116 & 155 for 2
- Total time not to exceed 5 mins
-
XR Takeoff thrust temp up to 970 are permitted up to
5 mins
-
APU EGT may exceed ___ up to ___ for ___ mins Max
680 - 717 for 5 mins
-
All XR takeoff thrust ITT between ___ - ___ are time limited to ___
971 - 992 for 90 secs
-
After start, Engines must run @ idle or taxi for ___ for cold, or ___ for warm.
4 mins cold 2 mins warm
-
AutoPilot Disengage Height
- Visual = 200
- Cat I = 200
- Cat II = 85
- Non Prec = before leaving MDA
-
For non XR a/c, flaps 45* speed of 145 must not be exceeded. However momentary deviations of ___kts can occur w/out MX
160 kts
-
Max Flap Ext speed flaps 22
200
-
Max ISIS duration (non XR) when on batteries is ___mins. Maybe extended to ___mins if Pitot 3 is off and not in icing
40 mins 45 mins
-
Dry Motoring continuous operation
___ on
___ off
-
The EMB 145 is certified in the following conditions
Day, Night, VFR, IFR, Icing
-
Max Flap Ext speed flaps 45
145
-
-
For models equipped with Fadec 7.6 or greater Min/ Max Oil Pressure < 88% N2
34 , 110
-
Vlo Retract/Extention
200 , 250
-
Min / Max Takeoff and Landing Pressure Alt
- ER/LR = -1,000 , 8,000
- XR = -1,000 , 10,000
-
-
Max Diff OVER Pressure
8.1
-
-
Max Temp for Anti ice Operation
10
-
To Increase N2 above 83 % Engine Oil temp must be at 40* C. In lieu of this, run Engines for at least 8 mins or complete a static runup to 88% N2 and chk oil pressure is equal to or less than 83 psi
:)
-
Max Oil Press may be exceeded during start if the Oil temp is below ___. Engine must remain at idle until Oil Press is less than ___
21 , 110
-
Min Oil Temp for start
-40
-
Min Battery temp for APU start
-20
-
Min / Max SAT @ FL370
-65 , -21.5
-
Max Airspeed after T/O climb without Re-Trimming
160
-
Engine is considered Cold if shut down for more than
90 mins
-
Engines must run for at least ___ Idle before shutdown
2 mins
-
Start Cycle APU
- 1st = 1 min off
- 2nd = 1 min off
- 3rd = 30 mins off
-
-
Max Differential Pressure
7.8
-
Above 10,000 with Yaw Damp disengaged, Max speed flaps 45 XR
145
-
Airplane must not be moved during powerup. Do not cage ATT indicator during flight
:)
-
LP & HP Spool Vibration limits may be exceeded up to ___ for ___ for T/O and G/A phases of flight, or for ___during all other phases
- 2.5 ips for 5 mins
- 10 secs
-
Max Windsheild Wiper operating speed
170
-
Max Operationl Alt for APU
FL 370
-
Min / Max SAT for takeoff
-40 , 52
-
Engine START Cycle
- 1st - 4th = 1 min on, 1 min off
- 5th = 1 min on, 5 min off
-
MX Inspection needed when landing below
-40
-
Above 10,000 with Yaw Damp disengaged, Max speed flaps 22 XR
180
-
-
Max Alt for APU start
FL 300
-
Max CrossWind T/O and Land
30
-
Max flap Ext speed flaps 9
250
-
Min AutoPilot engagement height
500 ft
-
-
XR T/O thrust / ITT between ___&___ are time limited to
971 - 992 90 secs
-
Takeoff thrust Temps up to 970 are permitted up to
5 mins
-
Min / Max Fuel tank Temp
-40 , 52
-
Max Imbalance bewteen tanks
800 lbs
-
Aircraft equipped with Fadec 7.6 or greater will display Oil Pressure up to and including ___psi in Green
110
-
Max Runway Slope
+/- 2% of runway length
-
Max Load APU above FL300
300 amps
-
APU will shutdown automatically at
104% rotor speed
-
For non XR a/c, when flaps are ext/retrac from 22*, momentary deviations between 200 and ___kts will not require MX
210
-
TAT above FL250 is limited to
-45 (moment devia can occur down to -50)
-
All ER/LR Takeoff thrust ratings and ITT limits are time limitted to
5 mins
-
On XR a/c, operation between 34 & 48 psi is permitted for a max of
5 mins T/O and G/A phases
-
Max Airspeed for turbulent air pen below 10,000ft and above 10,000ft
- below = 200 kts
- above = 250 or .63M whichever is LOWER
-
Max Flap ext speed flaps 18
200
-
Max Temp for Aircraft
ISA +35
-
Min Temp for Manual Anti-Ice
-40
-
Holding Config In ICING
- Gear = UP
- Flaps = 0*
- Min Speed = 200
-
Max Alt for Flap Extention
FL 200
-
Max Flap Ext speed flaps 45 XR
160
|
|