t44After start checklist

  1. Environmental Controls
    Set (RS)
  2. DC Generator Voltages
    • Checked (LS)
    • - should be 28.25 +- 0.8 V
  3. Inverters
    • ON (PF)
    • - either inverter on: check all AC buses powered, respective INVERTER OUT and INST INV out extinguished
  4. AC Voltages and Frequencies
    • Checked (LS)
    • Freq: 400 +- 6
    • Voltage 114 +- 7
  5. Avionics Master
    ON (PF)
  6. ** HOLD THE CHECKLIST
    "hold the checklist, keep right side clear during all ground operations"
    • Pilot Brake Check
    • CP call base on VHF
    • "Montana base, Montana 4XX out of the chocks"
  7. ** CONTINUE THE CHECKLIST
  8. Transfer Pumps
    • Checked/Auto (LS)
    • - Use transfer test switch L or R and move Transfer pump swith from OFF to AUTO
    • - should see momentary flash of LH/RH no FX trans
  9. Crossfeed
    • Checked/Auto (LS)
    • a. crossfeed auto
    • b. left boost pump OFF
    • c. left boost pump ON
    • d. Crossfeed CLOSED, then AUTO
    • e. Right Boost pump- OFF
    • f. Right Boost pump - ON
    • g. crossfeed Closed, then AUTO
  10. Generator Load
    • Checked (LS)
    • - ensure N1 rpm is enough to support generator load
    • - check load is <0.5
  11. RADAR
    Off (CP)
  12. **HOLD THE CHECKLIST
    Copy ATIS (UHF1), put cleearance on request, request taxi to run up
    • Power levers into reverse to verify operation, back to Beta (ensure symmetric ENGINE spool up)
    • - check CP brakes
  13. *** continue checklist
  14. Turn Indicators/Compasses
    • Checked (PF, PM)
    • - "check needle left, ball right, mark heading XXX"
    • - "Needle Left, ball right, mark heading XXX"
  15. Brakes
    Checked (PF, PM)
Author
Aflax12
ID
74095
Card Set
t44After start checklist
Description
T44 After Start checklist
Updated