-
Six reasons to prune trees
- Remove dead branches
- Remove crossing branches
- Remove lower limbs that interfere with traffic
- To slow growth
- To reduce wind throw
- To increase light penetration
-
Ring shakes
The separation of xylem circumferentially along annual rings caused by flush cuts
-
Natural Target Pruning
Removal of a branch at a line intersecting the branch bark ridge and branch collar
-
Branch bark ridge
A raised line of bark that forms on the upper side of where the branch joins the trunk.
-
Branch collar
A distinctive bulge at the base of the branch, where it connects to the trunk.
-
Drop crotch
A dominant leader is cut back to a lateral branch
-
Deadwooding
Removal of dead, weak and dying branches
-
Crown cleaning
Removal of dead, diseased, crowded, weakly attached, low-vigor branches and water sprouts from a tree crown
-
Crown thinning
Includes crown cleaning as well as the selective removal of branches to increase light penetration and air movement, reducing weight.
-
Crown reduction
Drop crotch pruning. Reduction of limbs to branches capable of assuming the terminal role (must be at least 1/3 size)
-
Crown restoration
Take a few of the best sprouts resulting from topping and train them over years to become branches
-
Crown raising
Removing lower branches to provide clearance for vehicles and pedestrians
-
Rule of thirds
When removing a branch, cut it back to a branch at least 1/3 the diameter
Do not remove more than 1/3 the total leaf surface in any one pruning
-
Timing to cable/brace
- Do not cable/brace during spring growth or leaf fall
- Prune prior to cable/brace
-
Four Patterns of Cabling
- Direct
- Triangular
- Box/Rotary
- Hub and Spoke
-
Types of Cable Hardware
- Threaded Rod- when decay is likely
- Eye bolts- use in decayed tree
- Amon eye nuts
- Lag hooks- no decay
-
Rules of Cabling
- Cables installed directly across the crotch, 2/3 from crotch to end of limb.
- When more than one cable is installed on same branch, space 12 in apart and never directly above/below
|
|