1. Home
  2. Flashcards
  3. Preview

ABs ICs conditions

  1. Control rod drive (CRD) travels past position 48.
    AB.IC-1
  2. Lowering Drive Water flow
    AB.IC-1
  3. A Reactor Manual Control System (RMCS) fault and/or a rod motion block exists.
    AB.IC-1
  4. CRD Pump Trip
    AB.IC-1
  5. Loss of the Outboard MSIV indication (A RPS Bus)
    AB.IC-3
  6. RDCS STATUS “ACTIVITY CONTROLS DISAGREE”, Illuminated
    AB.IC-3
  7. Failure of the SRM OR IRM to insert OR retract
    AB.IC-4
  8. The TIP detector travels past the shield position
    AB.IC-4
  9. No response observed on the Nuclear Instrumentation.
    AB.IC-1
  10. Drive Water Header Pressure Abnormal.
    AB.IC-1
  11. Unexpected APRM deviations compared to the Heat Balance on CMS.
    AB.IC-1
  12. Instrument Air header pressure lowering
    AB.IC-2
  13. Loss of the Inboard MSIV indication (B RPS Bus)
    AB.IC-3
  14. ROD MOTION BLOCKS “INSERT BLOCK” and “WITHDRAW BLOCK”, Illuminated
    AB.IC-3
  15. Failure of the APRM, LPRM OR RBM instrumentation.
    AB.IC-4
  16. Control Rod position does NOT change when an Insert OR Withdraw signal is applied.
    AB.IC-1
  17. Cooling Water Header Pressure Abnormal.
    AB.IC-1
  18. Activity Controls Disagree lamp illuminated
    AB.IC-1
  19. Scram Discharge Volume Level rising
    AB.IC-2
  20. Pilot Scram Valve trip actuator logic lights de-energize for LOGIC A or LOGIC B.
    AB.IC-3
  21. SRM or IRM instrumentation upscale OR downscale
    AB.IC-4
  22. Failure of the OPRM to enable
    AB.IC-4
Author
NuclearGuy
ID
352399
Card Set
ABs ICs conditions
Description
ABs ICs conditions
Updated

  1. Home
  2. Flashcards
  3. Preview