-
Black signal shielded distance to red processor.
5cm
-
Black signal shielded distance to red cable.
5cm
-
Black signal unshielded distance to red processor.
15cm
-
Black signal unshielded distance to red cable.
15cm
-
Number on the thru-bulkhead cable transit indicates what?
Diameter
-
What is the maximum lifespan of 2-2-1 weatherproofing?
12 months
-
What is acceptable XTL deviation?
3.8KHz-5KHz
-
What is the acceptable low power output for an XTL?
10 +/-1W
-
What is the acceptable high power output for an XTL?
20-25W
-
What is the acceptable resistance of DF dipoles?
>10M
-
If transciever's pwr out is bad, what should you do?
Reprogram once, then replace
-
If transciever's deviation is bad, what should you do?
Replace microphone, then replace transciever
-
When you start a new IR what do you get?
New IR Group
-
What are AFC-30 funds for?
Calibration
-
What are AFC-80 funds?
NTNO
-
What are the minimum trainings for ESDs?
- CPR
- General Electrical Safety
- Annual training for general electronic support
- Annual training for installed gear
-
What is shop stock limited to?
Items at $50 quantities for normal use
-
What is the form for a TEMPEST discrepancy?
4790CK
-
What are AFC-42 funds for?
Configuration management and replacing faulty test equipment
-
What does TMDE stand for?
Test, measurement, and diagnostic equipment
-
What is FSTER?
Fleet supplemental test equipment requirements
-
Fire tetrahedron includes what?
-
What are the 4 HERO classifications?
- Safe
- Susceptible
- Unsafe
- Unreliable
-
How far should hangar supports be?
32"
-
-
Single, double, and impact hearing protection.
-
What is the role of the maintenance supervisor?
Oversight of all Sector asset maintenance activities. Have the authority to maintenance release assets. Primarily assigned to EO or AEO.
-
How often are radars and transducers replaced on cutters?
4 years
-
How often are large antennas replaced on cutters?
6 years
-
Heat range for Skotchkote?
32-95F
|
|
