-
Loop
- 3C’s
- Set Power to MAX, 230-250 KIAS
- Clear overhead, report entry altitude.
- Pull 4 G’s in 2-3 seconds.
- Check wings in vertical and horizontal.
- Add right rudder to maintain alignment.
- Acquire horizon/reference line and pull through with 4 G’s.
-
Cuban Eight
- 3 C’s
- Set Power to MAX, 230-250 KIAS
- Clear overhead, report entry altitude.
- Pull 4 G’s in 2-3 seconds.
- After passing through the vertical, acquire opposite horizon.
- As nose approaches 45° below horizon, relax backstick and roll wings level.
- Maintain 45° nose low until commencing 2nd half.
-
Immelmann
- 3C’s
- Set Power to MAX, 230-250 KIAS
- Clear overhead, report entry altitude.
- Pull 4 G’s in 2-3 seconds.
- Check wings in vertical and horizontal.
- Add right rudder to maintain alignment.
- As nose approaches 10° above opposite horizon, relax backstick and roll wings level.
-
Split S
- 3 C’s
- Set Power to IDLE and decelerate to 140 KTS.
- At 140 KTS raise nose to 5-10° up.
- Roll inverted, neutralize ailerons, apply slight forward stick momentarily.
- Pull straight out 4 G’s.
- Check oil pressure within normal limits and report on ICS, reset power as required.
-
Aileron Roll
- 3 C’s
- Set Power to approx 80% TQ, 180-220 KIAS
- Raise nose approximatley 10° above horizon.
- Relax backstick.
- Roll the aircraft left or right using aileron.
-
Barrel Roll
- 3 C’s
- Set Power to approx 80% TQ, 200-220 KIAS
- Clear overhead, report entry altitude.
- Raise nose while keeping wings level.
- As nose passes 20° above horizon begin gradual roll to arrive at 45 position 55- 60° nose up and 90° AOB.
- Increase lateral stick in direction of roll to arrive at 90° position inverted.
- Go through the horizon looking over opposite shoulder to pick up section line.
-
Wing Over
- 3 C’s
- Set Power to approx 70% TQ, 200-220 KIAS
- Select reference point 90 off the wing
- Begin gradual climbing turn to 90 reference point
- Time to arrive 45 position with 45° nose up and 45° AOB
- The nose should arrive at 90 reference point with 90 AOB and nose on the horizon
- Passing horizon, let the nose fall, and begin rolling out of bank.
- The below horizon leaf should be symmetric to first leaf (nose above horizon)
- 2nd wingover turn same as 1st
-
Cloverleaf
- 3C’s
- Set Power to MAX, 200-220 KIAS
- 2-3 G’s initial nose up pull
- When 45° nose high, roll towards 90° reference point.
- Continue the pull and roll so the nose passes through reference point with wings level inverted (120 KIAS)
- Keep level and pull through the bottom (Spilt-S)
- Approaching horizon, pull through and start next leaf
|
|