-
From where does the refueling panel obtain power?
Right BATT bus
-
What is the minimum fuel quantity for a go-around?
500 lb per side
-
What are the pressure limitsfor SPPR?
-8 psig to 55 psig
-
What is minimum bulk fuel temperature using Jet A?
-30°
-
Assuming both engine run switches off, both fuel pumps in the automatic mode, and the APU knob selected to RUN, what EICAS message should appear?
Cyan R FUEL PUMP ON (A)
-
What assists the collector tanks in maintaining a full level of fuel?
Respective scavenge ejector
-
How much fuel can be added using overwing refueling?
13,000 lb
-
What is the total fuel capacity with single-point pressure refueling? Gravity refueling?
14,150 lb (6,420 kg) and 13,000 lb (5,900 kg)
-
What is the maximum zero fuel weight?
28,200 lb
-
How many fuel tanks does the Challenger 350 aircraft have?
Two tanks, each divided in three sections; main, collector, and surge tanks
-
When is fuel transfer prohibited?
Takeoff only
-
What are thefuel temperature limitations?
50°C maximum bulk fuel temperature, with 45° or more
-
Does the fuel x-fer valve need to be opened to refuel?
No
-
What are the limitationson fuel transfer?
No fuel transfer on takeoff
-
How many fuel pumps are installed?
- Nine:
- two engine-driven pumps,
- two electrical boost pumps,
- two main ejector pumps,
- two scavenge pumps,
- one APU mechanical pump
-
Single-point pressure refueling is limited to what psig?
55 psig
-
What power source is required to use SPPR?
Right BATT bus
-
What prevents fuel from traveling outboard during low-wing maneuvers?
Flapper valves
-
What is the maximum operation altitudefor JP-4 or JET B?
16,000 ft
-
How much fuel can be addedusing SPPR?
14,150 lb
-
How is the fuel heated?
Engine oil cooler/fuel heat exchanger
-
If the aircraft is not in level flight, what unit signals the fuel computer with an accurate fuel reading?
Inertial reference system (IRS)
-
How many water sumps are installed?
Six
-
What is the maximum negative pressure when defueling?
-8 psig
-
How many moving parts are in a jet pump?
None
-
In order to tranfer fuel, the XFER switch must be selected to ________ and one of the pumps selected to _________.
In order to tranfer fuel, the XFER switch must be selected to OPEN and one of the pumps selected to ON.
-
Why can engines only operate for 30 minutes with less than 1000 lb of fuel per side?
Overheating of the hydraulic fluid
-
Concerning the fuel venting system, from which area does air from the right wind NACA scoop originate?
Left main tank and right surge tank
-
During which phase of flight must the fuel XFER PBA be selected closed?
Takeoff
|
|
