A screwdriver may be used as a pry bar as long as it is sturdy enough for the application.
a) True
b) False
b) False
A three-legged pipe jack stand can be used for pipe up to _____ inches in diameter.
B) 6
The height of a three legged jack stand is typically adjusted by placing it on blocks.
a) True
b) False
b) False
The type of wrench that would be used on a chrome plated pipe is the ______ wrench.
D) strap
The tool shown in Figure 1 is a(n)________.
B) compound leverage pipe wrench
The term plumb relates to _______.
D) vertical alignment
A torpedo level is a good choice when accuracy is important
a) True
b) False
b) False
A framing level can be used to measure ______.
B) plumb or level
Which of the following is a task that cannot be performed with a framing square?
A) measuring the diameter of a pipe
Figure 2 shows a tool used to _____.
D) locate the center of a pipe
A t-joint welding clamp is used to hold a pipe section perpendicular to another pipe.
a) True
b) False
a) True
A Hi-Lo gauge is used to ______.
A) check pipe joint misalignment
A wraparound is used to ______.
D) draw a straight line around a pipe
Drift pins are used to _____.
B) align bolt holes on pipe flanges
A hacksaw blade used to cut copper tubing should have ______ teeth per inch.
D) 24
The tool shown in Figure 3 is used to cut _____.
B) carbon steel pipe
The tool shown in Figure 4 is used to _____.
D) thread pipe
Threading is complete when ____ full thread (s) extend(s) beyond the back edge of the die.
A) 1
Pipe taps are used to _____.
A) cut female threads of a pipe
Lever compression tube benders can be used to bend pipe up to 1 inch in diameter.
a) True
b) False
b) False
What is Burr?
Burr is a sharp, tagged edge of metal usually caused by cutting pipe.
What is Conduit?
Conduit is a round raceway, similar to pipe, that contains conductors.
What is die?
Die is a tool used to make male threads on a pipe or bolt.
What is female threads?
Female threads are threads on the inside of a fitting
What is Flare?
Flare is a pipe end that has been forced open to make a joint with a fitting
What is male threads?
Male threads are threads on the outside of a pipe.
What is the outside diameter?
The outside diameter is a measurement of the outside width of a pipe.
What is Pipe-fitting?
Pipe-fitting is a unit attached to a pipe and used to change the direction of fluid flow, connect a branch line to a main line, close off the end of a line, or join two pipes of the same size or of different sizes.
What is a Ratchet?
A ratchet is a device that allows a tool to rotate in only one direction
What is tack welds?
Tack welds are short welds used to hold parts in place until the final weld is made.
What is a thread gauge? What else can it be called?
A tool used to determine how many threads per inch are cut in a tap, die, bolt, nut or pipe. Also called a pitch gauge.