arrl g3 pg 42-53 34Q.txt

  1. G1D02 What license examinations may you administer when you are an accredited VE holding a General Class operator license?



    A.
  2. G1D05 Which of the following is sufficient for you to be an administering VE for a Technician Class operator license examination?



    A.
  3. G1D07 Volunteer Examiners are accredited by what organization?



    D. The Wireless Telecommunications Bureau
    C.
  4. G1D04 Which of the following is a requirement for administering a Technician Class operator examination?



    A.
  5. G1D08 Which of the following criteria must be met for a non-U.S. citizen to be an accredited Volunteer Examiner?



    B.
  6. G1D10 What is the minimum age that one must be to qualify as an accredited Volunteer Examiner?
    A. 12 years
    B. 18 years
    C. 21 years
    D. There is no age limit
    B
  7. G2B06 What is a practical way to avoid harmful interference when selecting a frequency to call CQ on CW or phone?



    D.
  8. G2B07 Which of the following complies with good amateur practice when choosing a frequency on which to initiate a call?



    B.
  9. G2B01 Which of the following is true concerning access to frequencies?



    B.
  10. G2A08 Which of the following is a recommended way to break into a conversation when using phone?



    A.
  11. G2A11 What does the expression "CQ DX" usually indicate?



    D.
  12. G4A03 What is normally meant by operating a transceiver in "split" mode?



    D.
  13. G4A12 Which of the following is a common use for the dual VFO feature on a transceiver?



    D. To facilitate computer interface
    C.
  14. G2B?? If propagation changes during your contact and you notice increasing interference from other activity on the same frequency, what should you do?



    D.
  15. G2B05 What is the customary minimum frequency separation between SSB signals under normal conditions?



    B.
  16. G4D10 How close to the lower edge of the 40 meter General Class phone segment should your displayed carrier frequency be when using 3 kHz wide LSB?



    A.
  17. G4D08 What frequency range is occupied by a 3 kHz LSB signal when the displayed carrier frequency is set to 7.178 MHz?



    C.
  18. G4D11 How close to the upper edge of the 20 meter General Class band should your displayed carrier frequency be when using 3 kHz wide USB?



    D. Center your signal on the edge of the band
    B.
  19. G4D09 What frequency range is occupied by a 3 kHz USB signal with the displayed carrier frequency set to 14.347 MHz?



    A.
  20. G4A11 Which of the following is a use for the IF shift control on a receiver?
    A. To avoid interference from stations very close to the receive frequency
    B. To change frequency rapidly
    C. To permit listening on a different frequency from that on which you are transmitting
    D. To tune in stations that are slightly off frequency without changing your transmit frequency
    A
  21. G2D10 What is QRP operation?



    C.
  22. G2A10 Which of the following statements is true of SSB VOX operation?



    D. Provides more power output
    B.
  23. G1E04 Which of the following conditions require an Amateur Radio station licensee to take specific steps to avoid harmful interference to other users or facilities?



    D.
  24. G1E06 Which of the following applies in the event of interference between a coordinated repeater and an uncoordinated repeater?



    D.
  25. G1E10 What portion of the 10 meter band is available for repeater use?



    D.
  26. G8B05 Why isn't frequency modulated (FM) phone used below 29.5 MHz?



    A.
  27. G2A05 Which mode of voice communication is most commonly used on the high frequency amateur bands?



    C.
  28. G2A06 Which of the following is an advantage when using single sideband as compared to other analog voice modes on the HF amateur bands?



    D.
  29. G2A07 Which of the following statements is true of the single sideband (SSB) voice mode?



    A.
  30. G2A04 Which mode is most commonly used for voice communications on the 17 and 12 meter bands?



    B.
  31. G2A01 Which sideband is most commonly used for voice communications on frequencies of 14 MHz or higher?



    C.
  32. G2A03 Which of the following is most commonly used for SSB voice communications in the VHF and UHF bands?



    B.
  33. G2A02 Which of the following modes is most commonly used for voice communications on the 160, 75, and 40 meter bands?



    D.
  34. G2A09 Why do most amateur stations use lower sideband on the 160, 75 and 40 meter bands?



    D.
Author
mwinstom
ID
277700
Card Set
arrl g3 pg 42-53 34Q.txt
Description
arrl
Updated