BRUSH 14 (#1598) - BRUSH 29 (#1907) - BRUSH 35 (#1908

Pump and Roll‖ can be selected at any road speed, the pump will engage when the rpm’s drop to 800-900 (―shift on the fly

For ―Pump and Stop‖, set the maxi brake and shift to neutral. Switch to ―Pump and Stop‖ and leave in neutral to pump

The pump can be engaged in either ―Auto‖ or ―Unload  on the pump panel (Auto-Sync switch

Auto is for CAF and ―Unload is for water only

Before pumping, the ―tank-to- pump valve should be open (always) and the ―tank fill cracked open slightly for cooling the pump

When pumping CAF, ensure that Foam Pro is on and at the correct % setting to avoid ―slug flow

• The discharge relief valve must be set to the discharge pressure for ―Pump and Roll so the Captain’s vernier throttle can be increased above the discharge pressure. This allows for power and torque to climb hills. 1900 rpm will give you ―Pump and Roll
• capability up a 70% grade. (140 psi for turret

In ―Pump and Roll , the Captain’s pressure gauge only reads pressure when the turret is actually flowing

• In ―Pump and Stop
• only the pump panel throttle works (when the maxi brake is set) (you can still use the turret, just throttle up from the pump panel

Don’t turn the steering wheel on a hard surface with the side different lock engaged as damage may occur to the axles

• The ―Load
• setting for the CTIS must be set for the water tank level