-
Max number of Passenger Seats
(375)
- Our Configuration:
- Bus - 18, Coach - 276, Total - 294
-
Max Taxi weight
526,684 lbs
-
Max Takeoff weight (brake release)
524,700 lbs
-
Max Landing weight
401,241 lbs
-
Max Zero Fuel weight
370,376 lbs
-
Min Landing weight
255,737 lbs
-
Flight Maneuvering Load Acceleration Limits
Clean: -1g to +2.5g
Other configs: 0g to +2g
-
-
Runway slope (mean)
+/- 2%
-
Runway altitude
12,500 ft
-
Max certified Crosswind for Takeoff
32 kts (gust included) - AFM Engine Limitation
-
Max demonstrated Crosswind for Landing
45 kts (gust included) - NOT an AFM Limitation
-
Max Tailwind for Takeoff
15 kts
-
Max Tailwind for Landing
10 kts
-
Max wind for Passenger Door operation
40 kts / 50 kts if aircraft nose is oriented into the wind
-
Max wind for Cargo Door operation
40 kts / 50 kts if aircraft nose is oriented into the wind or the cargo door is on the leeward side
-
Passenger/Cargo Door must be closed before wind speed exceeds
60 kts
-
-
-
Mva (Max design Maneuvering speed)
.78 mach
If alternate/direct law is active, full ailerons, full rudder application, and maneuvering at aoa near stall should be confined below Mva.
-
Max altitude with Flaps and/or Slats Extended
20,000 ft
-
Max Flaps/Slats speed
Lever position 1 - Holding (1 on ECAM)
240 kts
-
Max Flaps/Slats speed
Lever position 1 - Takeoff (1+F on ECAM)
215 kts
-
Max Flaps/Slats speed
Lever position 2 - Approach (2a on ECAM)
205 kts
-
Max Flaps/Slats speed
Lever position 2 - Takeoff/Approach (2 on ECAM)
196 kts
-
Max Flaps/Slats speed
Lever position 3 - TO/APPR/LDG (3 on ECAM)
186 kts
-
Max Flaps/Slats speed
Lever position FULL - LDG (FULL on ECAM)
180 kts
-
Max speed with Gear Extended (Vle)
250 kts / .55 mach
-
Max Gear Operating speed (Vlo)
250 kts / .55 mach
-
Max speed for Gravity Extension (Vle, Vlo)
200 kts
-
Max altitude for Gear Extension
21,000 ft
-
Max Tire speed
204 kts on ground
-
Max speed for Windshield Wiper operation
230 kts
-
Max speed with Cockpit Window open
230 kts
it's not possible to open cockpit windows with packs ON
-
Max speed for Speedbrake operation
No limitation
-
Vmcl (Min Control speed)
118 kts
-
Max Positive Differential Pressure
+9.25 psi
-
Max Negative Differential Pressure
-0.73 psi
-
Safety Relief Valve setting
+8.85 psi / -0.26 psi
-
Ram Air Inlet opens when differential pressure is lower than
1 psi
-
Air Flow supplied by Two Ground Carts should not exceed
2 x 3.53 lb/sec
-
Simultaneous use of Conditioned Air from Packs and LP Ground Units should be
avoided
-
Using HP Ground Unit when APU supplies Bleed Air could cause
bleed system damage
-
Min weight for use of Autoland
271,166 lbs
-
Min height for use of Autopilot on Takeoff with SRS mode
100 ft AGL
FMGS logic prevents autopilot from engaging during 5 sec after liftoff
-
Min height for Autopilot use on Straight-in Non-Precision approach
Applicable MDA/MDH
-
Min height for use of Autopilot on Straight-in LNAV/VNAV approach
Applicable DA
-
Min height for use of Autopilot on Circling approach
Applicable MDA/MDH - 100 ft
-
Min height for use of Autopilot on ILS approach when CAT2/CAT3 Not Displayed on FMA
160 ft AGL
-
Min height for use of Autopilot on Go-Around (AP or FD engagement)
100 ft AGL
-
Use of AP or FD in OPEN DES or DES mode is not permitted unless FCU Altitude is set to or above
MDA/MDH or 500 ft (whichever is highest)
-
Use of Autothrust is approved with or without AP/FD in which modes?
Selected or Managed mode
-
Min Decision Height - CAT2
100 ft AGL
at least one autopilot must be engaged in APPR mode and CAT2, CAT3 SINGLE or CAT3 DUAL must be displayed on FMA
-
If Auto Approach performed without Auto Land, Autopilot must be disengaged no later than
80 ft AGL
-
Min Decision Height - CAT3 Fail Passive
50 ft
one autopilot in APPR mode, CAT3 SINGLE or CAT3 DUAL must be displayed on FMA
-
Alert Height - CAT3 Fail Operational
200 ft
-
Min RVR - CAT3 without DH
75 meters
-
CAT2 and CAT3 Fail Passive autoland with Engine Out are approved in Config __, and if Engine Out Procedures are completed before reaching _____ ft in approach
Config 3, 1000 ft
-
Max Headwind for CAT2/3 Auto Approach or Auto Land and Auto Rollout
35 kts
-
Max Tailwind for CAT2/3 Auto Approach or Auto Land and Auto Rollout
10 kts
-
Max Crosswind for CAT2/3 Auto Approach or Auto Land and Auto Rollout
15 kts
-
Approved Configurations for CAT2/3 Autoland
CONF3 and CONF FULL
-
It is forbidden to use Electrical Outlets during
Takeoff and Landing
-
Max allowable Wing Fuel Imbalance:
Inner tanks (outer balanced), Heavier tank FULL
6,400 lbs
-
Max allowable Wing Fuel Imbalance:
Inner tanks (outer balanced), Heavier tank HALF
10,500 lbs
-
Max allowable Wing Fuel Imbalance:
Inner tanks (outer balanced), Heavier tank 16,500 lbs
16,500 lbs
-
Max allowable Wing Fuel Imbalance:
Outer tanks (inner balanced), Heavier tank FULL
3,260 lbs
-
Max allowable Wing Fuel Imbalance:
Outer tanks (inner balanced), Heavier tank 5,290 lbs
3,480 lbs
-
Max allowable Wing Fuel Imbalance:
Outer tanks (inner balanced), Heavier tank 3,810 lbs
3,810 lbs
-
Max Fuel Temp
+55 degrees C, +49 degrees C (JP4, JET B)
-
Min Fuel Temp
- Inner Tank: Freezing Pt or
- -44 degrees C below 30,000 ft or
- -54 degrees C above 30,000 ft
- whichever is higher.
Outer or Trim Tank: Freezing Pt
-
Min Fuel Quantity for Takeoff
11,460 lbs
WING TK LO LVL must not be displayed on ECAM for takeoff
-
Fuel Tanks must be Emptied in following order:
Center, then Wing Tanks
-
In case of Trim Tank Forward Transfer Pump failure, do not select the Trim Tank Forward when Pitch Trim is above
3 degrees to avoid inadvertent fuel aft transfer
-
Transfer from Center to Inner, when using JP4, is possible up to
20,000 ft
-
Normal Hydraulic Pressure is
3000 psi +/- 200
-
Max Brake Temp for Takeoff
300 deg C
-
Nosewheel Steering Angle is limited to
72 degrees
-
For Towing and Pushback, Nosewheel Steering Angle is limited to
65 degrees
-
If Tire Damage is suspected after Landing or Rejected Takeoff
inspection of tires is required before taxi
-
If Tire is Deflated but not Damaged the aircraft can be Taxied at low speed with the following limitations
If one tire is deflated on one or more gears (max of 3 tires), the speed should be limited to 7 kts when turning
If two tires are deflated on the same gear (other main gear tires ok), speed should be limited to 3 kts and nosewheel steering angle limited to 30 degrees
-
When both PFD's are lost the ISIS bugs function
must not be used
-
EGPWS Enhanced function should be limited within 15 nm from the airfield when
operating to/from runways not in EGPWS database
specific approach procedures have previously been identified as potentially producing false terrain alerts
-
Min Flight Crew Oxygen pressure at 50 deg C (122 deg F) for 2 crew + 2 obs
1000 psi
Provides 15 min on NORMAL (emergency descent) or
15 min on EMERGENCY (smoke) at 8,000 ft cabin alt
-
Min Flight Crew Oxygen pressure Reference Temp
- Ground:
- (OAT + Cockpit Temp)/2
- Flight:
- Cab Temp (deg C) - 10 deg C or
- Cab Temp (deg F) - 18 deg F
-
If APU is started with LOW OIL LEVEL ECAM advisory
Maintenance action is required within next 15 hrs of APU operation
-
APU Starter limits
3 consecutive start attempts without cool down, then 60 min cooling interval before next start
-
APU max Rotor Speed (N)
107%
-
-
APU max EGT for start
1250 deg C
-
APU Bleed Air is not permitted for
wing anti-ice
-
When JET B or JP4 is used, APU operation is limited to
25,000 ft
-
APU Bleed Air extraction with Generator Load in flight
one pack: 22,500 ft
eng start: 20,000 ft
two packs: 17,500 ft
-
APU Electric Power extraction only (in flight or on ground)
115 kva (100%)
-
Time / EGT limits - TOGA
20 sec / 920 deg C
5 min / 900 deg C
10 min / 900 deg C (Engine Failure)
-
Time and EGT limits - MCT
no time limit / 850 deg C
-
Time and EGT limits - Eng Start
no time limit / 700 deg C
no time limit / 850 deg C (Air start)
-
Max Engine Oil temp
190 deg C
-
Min Engine Oil temp for Takeoff
20 deg C
-
Min Engine Oil pressure
25 psi
-
Min Engine Oil quantity
17 qts
-
Max Engine N1, N2 and N3
N1: 99% (or lower depending on ambient conditions and eng bleed config)
N2: 103.3%
N3: 100%
-
Engine Starter limits
5 min - max continuous operation
- Two - 3 min duty cycles and
- One - 1 min cycle
- (N3 down to zero between each cycle)
Wait 30 min - after one continuous operation or three cycles
- No running engagement of starter when N3 is above:
- 10% (ground) / 30% (flight)
-
Reverse Thrust in flight
prohibited
-
Revers Thrust to back aircraft
prohibited
-
Min speed for Max Reverse
70 kts
Idle reverse is allowed down to aircraft stop
-
Takeoff at Reduced Thrust permissible only when
Airplane meets all applicable Performance Requirements at the Planned Takeoff Weight with operating engines at Thrust Available for Assumed Temp
-
Flex Temp must not be higher than
ISA + 60 deg C (T MAX FLEX)
-
Assumed Temp must not be lower than
flat rating temp or actual OAT
-
Takeoff at Reduced Thrust is not permitted on
contaminated runways
-
Takeoff at Reduced Thrust is allowed with any Inoperative Item affecting performance only if
Associated Performance Shortfall has been Applied to meet all Performance Requirements at Takeoff Weight with operating engines at Thrust Avail for Flex Temp
|
|