CCNA Chapter 15 IPv6

  1. What is the IPv6 loop back address to check the tcp/ip protocol stack?
    It is ::1 this is the same as IPv4
  2. What the IPv6 global unicast address range?
  3. What is the IPv6 unique local unicast range?
  4. What is the IPv6 link-local unicast range?
  5. What is the IPv6 multicast range?
  6. How do you enable IPv6 routing on a Cisco router?
    • Router(config)#ipv6 unicast-routing
    • You turn it on by typing this at the global configuration mode.
    • You alslo have to enable it on each interface due to ipv6 forwarding being disabled on the by default.
  7. What is the syntax for setting an IPv6 address?
    Router(config-if)#ipv6 address FF13::23 / 64
  8. What is the IPv6 version of RIP? and how do you enable it?
    • RIPng
    • Router(config-if)#ipv6 router rip 1 
    • It is inabled on the interface and does not use a network command. 
  9. What is the IPv6 version of EIGRP? and how do you enable it?
    • EIGRPv6
    • Router(config)#ipv6 router eigrp 10
    • Router(config-rtr)#no shutdown
    • Router(config-if)#ipv6 eigrp 10
    • EIGRPv6 is still enabled in global configuration mode and applied to the interface in its configuration mode.
  10. What is the IPv6 version of OSPF? and how do you enable it?
    • OSPFv3
    • Router(config-if)#ipv6 ospf 10 area
    • OSPFv3 can be set at the interface and it will be added to the global configuration proccess automaticly
Card Set
CCNA Chapter 15 IPv6
CCNA Chapter 15 IPv6