-
-
-
VFE Slats + Flaps 20°
190 KIAS
-
VFE Slats + Flaps 48°
175 KIAS
-
VLE/MME
220 KIAS / .75 Mach
-
VLO/MLO
190 KIAS / .70 Mach
-
-
VMO/MMO
- Sea Level: 350 KIAS
- 0' MSL to 10K': 350 - 370 KIAS
- 10K' to 24K': 370 KIAS
- Above 24K': .86 Mach
-
AUTO SLAT Light On
270 KIAS
-
Cracked Windshield
230 KIAS
-
-
Either/Both Hyd Inop
260 KIAS / .76 Mach
-
Mach Trim Inop w/ No A/P
.78 Mach
-
Thrust Reverser Deployed
230 KIAS
-
-
Turbulent Air Penetration
280 KIAS / .76 Mach
-
VWWO - Windshield Wiper Ops
205 KIAS
-
TFE 731-40-1C
Ground Start ITT
991 °C
-
TFE 731-40-1C
Airstart Start ITT
991 °C
-
TFE 731-40-1C
Takoff ITT
1013 °C for 5 Minutes Max
-
TFE 731-40-1C
Max Continuous ITT
991 °C
-
TFE 731-40-1C
Max Cruise ITT
974 °C
-
TFE 731-40-1C
Takeoff/Max Continuous N1%
100.1%
-
TFE 731-40-1C
Takeoff/Max Continuous N2%
101.0%
-
TFE 731-40-1C
Transient Max Allowable N1%
100.5% for 5 Seconds Max Allowable
-
TFE 731-40-1C
Transient Max Allowable N2%
102.5% for 5 Seconds Max Allowable
-
TFE 731-40-1C
Max RPM in Reverse
84.0% N1
-
TFE 731-40-1C
Grnd Start from 10% N2 to Lightoff
10 Seconds Maximum
-
TFE 731-40-1C
Grnd Start from Lightoff to Idle
60 Seconds Max
-
TFE 731-40-1C
Windmilling Airstart
No Time Limit
-
TFE 731-40-1C
Start Assist Airstart from Fuel Flow N2 to 60% N2
45 Seconds Maximum
-
TFE 731-40-1C
Thrust Rating
- 3700 Lbs - Takeoff
- 3641 Lbs - Max Continuous
-
TFE 731-40-1C
Oil Temperature
- 0' MSL to FL300: 127 °C
- Above FL300: 140 °C
- Transient: 149 °C
- Minimum: -40 °C
- Min above Idle: +30 °C
-
TFE 731-40-1C
Oil Pressure
- Takeoff or Max Continuous: 65-80 psi
- Idle: 50-80 psi
- Transient: 100 psi Max (<3 Minutes)
-
-
-
-
Max Zero Fuel Wt
25,570 Lbs
-
-
Max Baggage Weight
2200 Lbs
-
Max Baggage Loading
123 Lbs/ft2
-
-
Max Alt w/ Slats or Flaps Extended
20,000'
-
Max Alt for Stby Hyd Pump Inop
45,000'
-
Max Gs
- Flaps Up: +2.6 to -1
- Flaps Down: +2 to 0
-
Max Δ P: Overpressure Relief Valve
9.5 psi
-
Max Δ P: Baggage Overpressure Relief Valve
9.7 psi
-
Cabin Altitude Limiter
14,500'
-
Battery Temp
- > 150 °F
- or
- > 160 °F with digital BAT TEMP indicator
-
-
Gen Max Amp
- Transient (1 Min Max): 350 A
- Up to 39,000': 300 A
- Above 39,000': 250 A
-
Fuel Quantity HI Level Feeders
15,514 lbs
-
Fuel Quantity LO Level Feeders
13,213 lbs
-
Regulation Level for all Feeder Tanks is
609 lbs (91 gallons)
-
Fuel Quantity Indicator Selector switch should normally be left in the _____ position
REAR
-
Transfer Pumps should be switched ___ when no fuel left in wing tanks
OFF
-
With illumination of the ____ ____ light, stop pressure refueling
STOP FUELING
-
Max Feed Pressure (SPR)
50 psi (3.5 bars)
-
In extended cruise in cold temps, if necessary, ____ ____ or ____ ____ to raise TAT
- Increase Mach
- Decrease Altitude
-
Engine Anti-Ice should be ON when total temp is below ___ °C in visible moisture
+5 °C
-
Engine Anti-Ice should be OFF when total temp is above ___ °C in visible moisture
+10 °C
-
Wing Anti-Ice must be OFF when total temp is above ___ °C in visible moisture
+10 °C
-
Both Pilot's & Copilot's Windsheild Heat switches should be set to the ___ ___ ___
Same operating position
-
Do not operate ____ Anti-Ice on the ground except for Maintenance Checks cnducted in accordance with the Maintenence Manual.
Wing Anti-Ice
-
Airbrake control handle should be held until proper ____ /____ is ascertained
extension / retraction
-
If ___ or ___ is inadvertantly exceeded, do not hesitate to use the ____
-
In flight, extend ____ to next detent only after cessation of movement to the ____ ____
-
Do not extend flaps if the ___ green light is off
Slats
-
CAUTION: Above ____ feet, do not establish or maintain flaps or slats extended
20,000'
-
Airport Pressure Altitude
-1,000' to 14,000'
-
Max Water depth for Takeoff
3/4"
-
Max Demonstrated Crosswind
30 Kts
-
Max Runway Slope
+2.5% to -2.5%
-
Limiting Tailwind Component
10 Kts
-
Engine Syncronizer must be OFF for ___, ___ & ___
Takeoffs, Landings & Missed Approaches
-
Engine Computers must be ____ for Takeoff
Operative
-
Engine low pressure rotor speed ___ is the thrust setting parameter
N1
-
Takeoff and Max Continuous thrust must be based on ___ values given in the AFM, Section V, unless ___ is limiting
N1; ITT
-
Min O2 below 10,000' without passengers
650 psi
-
Min O2; 2 Crew with 10 or less pax to FL410
700 psi
-
Min O2 above FL410
Check Ops Manual
-
-
APU Max EGT Allowed
732 °C
-
APU Max Generator Load
300 Amp
-
-
APU Max Speed Allowed
110%
-
APU approved for ____ use only
Ground
-
APU bleed must be ___ for Engine of Airframe Anti-Ice checks
OFF
-
Discontinue APU Start (Stop pushbutton) if T5 does not rise within ___ seconds.
10
-
Wait ___ minutes before attempting a 2nd APU start
5
|
|