The effective throat of a fillet weld is computed by measuring the shortest distance between what two points?
D. Root to Face
Fillet welds in holes and slots are not considered to be :
C. considered a plug or slot
On an E7018, what does the digit "1" indicate:
C. welding position
Flux cored arc welding is regulated by which of the following AWS numbers:
C. AWS. A 5.20
The welding joint for a round bar welded to a flat plate is :
A. flare bevel
When two round bars are welded lenth wise, what type of welding joint would it be?
D. flare-vee
A splice may be done in the field only when:
B. supervised by the deputy welding inspector
The document that should be made available to the person doing the welding is :
C. both A and B ( AWS code book and welding procedure specification)
A fillet weld, when measured for size, shall be measured:
C. shortest leg
When complete joint penetration groove welds are made without backing, the weld is achieved when:
B. Back gouged and back beaded
Which of these electrodes has an iron powder coating?
C. E7024
Which of the SMAW electrodes has an iron powder and low hydrogen coating?
C. E7018
What is the minimum length of an intermittent fillet weld?
D. 1 1/2 "
Complete joint penetration groove welds made without the use of steel backing, shall have the root gouged to sound metal before welding is started on the other side:
A. Always
Which gas is most hazardous to the SMAW process?
C. Hydrogen
Which gas is most hazardous to weld metal?
D. all of the above
Which electrode group designation is used for low hydrogen?
B. F4
When you heat a structure after completing the weld, it is referred to as :
C. post-weld heating
The standard of welding symbols will be found under: