ccna-commands

What is the command to display the MAC addresses on a switch?

show mac-address-table
What command is used to show information about neighboring switches on Cisco devices?

show cdp neighbors
What command is used to show the routing table?

show ip route
What command displays a summary of the interfaces?

show ip interface brief
What is the command to configure a static route?

ip route <ip> <mask> <next hop | interface>
What command is used to show the current configuration?

show running-config
What command is used to show the mapping of IP addresses to MAC addresses?

show ip arp
What command shows the version of the Cisco switch?

show version
What commands shows information about VLANs?
- show vlan
- show interface vlan
What commands show information about the VLAN Trunking Protocol?
- show vtp status
- show vtp status brief
How do you configure the RIP process?
- router rip
- network <IP_network_#>
- version 1|2
How do you configure IGRP?
- router igrp <autonomous_system_#>
- network <IP_network_#>
How do you configure the OSFP process?
- router ospf <process_ID>
- network <IP_address> <wildcard> area <area_#>
How do you configure EIGRP?
- router eigrp <autonomous_system_#>
- network <IP_network_#>
How do you configure Frame Relay?
- interface serial <[slot_#]/port_#>
- encapsulation frame-relay [cisco|ietf]
- frame-relay lmi-type ansi|cisco|q933a
What command is used to show information about the spanning tree protocol?

show spanning-tree

Author

gunbustr

121984

Card Set

ccna-commands

Description

Useful CCNA commands

Updated

2011-12-10T07:47:58Z