-
-
-
VFE Slats + Flaps 20°
190 KIAS
-
VFE Slats + Flaps 48°
175 KIAS
-
VLE/MME
220 KIAS / .75 Mach
-
VLO/MLO
190 KIAS / .70 Mach
-
-
VMO/MMO
- 0' MSL to 10K': 350 - 370 KIAS
- 10K' to 24K': 370 KIAS
- Above 24K': .86 Mach
-
AUTO SLAT Light On
270 KIAS
-
Cracked Windshield
230 KIAS
-
-
Either/Both Hyd Inop
260 KIAS / .76 Mach
-
Mach Trim Inop w/ No A/P
.78 Mach
-
Thrust Reverser Deployed
230 KIAS
-
-
Turbulent Air Penetration
280 KIAS / .76 Mach
-
Windshield Wiper Ops
205 KIAS
-
TFE 731-3-1C
Starting Grnd/Air-Norm ITT
907 °C
-
TFE 731-3-1C
Starting Grnd/Air-Transient ITT
927 °C for 10 Seconds
-
TFE 731-3-1C
Starting Grnd/Air-Transient ITT
(Max)
977 °C for 5 Seconds
-
TFE 731-3-1C
Takeoff-Normal N1%
101.5%
-
TFE 731-3-1C
Takeoff-Normal N2%
100%
-
TFE 731-3-1C
Takeoff-Normal ITT
907 °C for 5 Minutes
-
TFE 731-3-1C
Takeoff-Transient ITT
(MAX)
917 °C for 10 Seconds
-
TFE 731-3-1C
Max Continuous
N1%; N2%; ITT
101.5%; 100%; 885 °C
-
TFE 731-3-1C
Transient (MAX)
N1%; N2%
- 103%; 103% for 1 Minute
- 105%; 105% for 5 Seconds
-
TFE 731-3-1C
Grnd Start/Starter Assist
Airstart fm 10% N2 to Lightoff
10 Seconds Maximum
-
TFE 731-3-1C
Windmilling Airstart from
Windmilling N2 to 60% N2
25 Seconds Maximum
-
TFE 731-3-1C
Grnd Start; Lightoff to Idle
50 Seconds Maximum
-
TFE 731-3-1C
Thrust Rating
- 3700 Lbs - Takeoff
- 3700 Lbs - Max Continuous
-
TFE 731-3-1C
Oil Temperature
- 0' MSL to FL300: 127 °C
- Above FL300: 140 °C
- Transient: 149 °C
- Minimum: -40 °C
- Min above Idle: +30 °C
-
TFE 731-3-1C
Oil Pressure
- Max Toff/Cont/Idle: 46 psi
- Min Toff/Cont: 38 psi
- Min Idle: 25 psi
- Max Transient: 55 psi (<3 Minutes)
-
TFE 731-3-1C
Engine Start Abort Conditions
- Oil psi does not rise w/in 10 seconds after lightoff
- ITT does not rise w/in 10 seconds after pwr lvr to Idle
- ITT is rising rapidly & approaching the 907 °C limit
- N1 remains close to 0% when N2 is 20%
- N2 speed is not rising rapidly & smoothly to idle after pwr lvr advanced to Idle
- N2 fails to rotate
- N2 fails to reach 10% in 6 seconds
- Unusual noise is heard or vibration is detected
- **During a start, a +/- 5% N1 speed variation is normal
-
TFE 731-3-1C
Thrust Reverser
- Thrust Reverser approved for ground use only
- Thrust Reverser must not be used for taxiing in reverse
- On landing, do not attempt a go-around after reverse thrust is selected
- With a Thrust Reverser deployed in flight, reduce to 230 KIAS or less
- Recommended 30 seconds max continuous use & 4.5 minutes between uses
- Full reverse thrust usable until completely stopped; in crosswinds, a 5% reduction of N1 is recommended shortly before completly stopped
- Dassault recommends checking reverse thrust is limited automatically to a max of 93% N1
-
Max Ramp Wt
- 38,800 Lbs
- 40,780 Lbs (SB F50-161)
-
Max Toff Wt
- 38,800 Lbs
- 40,780 Lbs (SB F50-161)
-
Max Ldg Wt
- 35,715 Lbs
- 33,070 Lbs (Unpaved Rwy)
-
Max Zero Fuel Wt
25,570 Lbs
-
-
Enroute Max Alt
- 45,000'
- 49,000' (SB F50-163)
-
Max Alt w/ Slats or Flaps Extended
20,000'
-
Max Alt for Stby Hyd Pump Operation
45,000'
-
Max Gs
- Flaps Up: +2.6 to -1
- Flaps Down: +2 to 0
-
Max Δ P: Pressure Controller
- 8.8 psi
- 9.1 psi (SB F50-163)
- Equates to Cabin Pressure Altitude of:
- 8,000' at FL450 (FL490 (SB F50-163))
-
Max Δ P: Overpressure Relief Valve
- 9.1 psi
- 9.5 psi (SB F50-163)
-
Max Δ P: Baggage Overpressure Relief Valve
- 9.3 psi
- 9.7 psi (SB F50-163)
-
Cabin Altitude Limiter
- 12,500'
- 14,500' (SB F50-154)
-
Battery Temp
- Amber Light: at or >120 °F
- Red Light: at or > 150 °F
-
-
Max Gen Output
- to 39,000': 300 A
- > 39,000': 250 A
- Transient (1 Min Max): 350 A
-
Max Inverter Output
750 A
-
Fuel Quantity HI Level Feeders
15,514 lbs
-
Fuel Quantity LO Level Feeders
13,213 lbs
-
Regulation Level for all Feeder Tanks is
609 lbs
-
Fuel Quantity Indicator Selector switch should normally be left in the _____ position
REAR
-
Transfer Pumps should be switched ___ when no fuel left in wing tanks
OFF
-
With illumination of the ____ ____ light, stop pressure refueling
STOP FUELING
-
Max Feed Pressure (SPR)
50 psi (3.5 bars)
-
In extended cruise in cold temps, if necessary, ____ ____ or ____ ____ to raise TAT
- Increase Mach
- Decrease Altitude
-
Engine Anti-Ice should be ON when total temp is below ___ °C in visible moisture
+10 °C
-
Engine Anti-Ice should be OFF when total temp is above ___ °C in visible moisture
+10 °C
-
Wing Anti-Ice should be OFF when total temp is above ___ °C in visible moisture
+10 °C
-
Both Pilot's & Copilot's Windsheild Heat switches should be set to the ___ ___ ___
Same operating position
-
Do not operate ____ Anti-Ice on the ground except for Maintenance Checks cnducted in accordance with the Maintenence Manual.
Wing Anti-Ice
-
Airbrake control handle should be held until proper ____ /____ is ascertained
extension / retraction
-
If ___ or ___ is inadvertantly exceeded, do not hesitate to use the ____
-
In flight, extend ____ to next detent only after cessation of movement to the ____ ____
-
Do not extend flaps if the ___ green light is off
Slats
-
CAUTION: Above ____ feet, do not establish or maintain flaps or slats extended
20,000'
-
Airport Pressure Altitude
- -1,000' to 10,000'
- -1,000' to 14,000' (SB F50-154)
-
Collins APS 80 & 85 Autopilot altitude limits
- Min engaged Enroute: 1,000'
- Min engaged Approach: 50'
- Radio Altimeter Inop: 100'
- Autopilot must be OFF for Toff & Ldg
-
Max Water depth on Runway; Demo'd
3/4"
-
Max Water depth on Runway; Recommended
1/2"
-
Max Demonstrated Crosswind
23 Kts
-
Max Runway Slope
+2.5% to -2.5%
-
-
Engine Syncronizer must be OFF for ___, ___ & ___
Takeoffs, Landings & Missed Approaches
-
Fuel Control Computers must be ____ for Takeoff
Operative
-
Rapid displacement of Power Levers on the ground may cause ___ ___ light to illuminate momentarily
ENG-2 FAIL
-
Takeoff and maximum continuous N1 setting of side engines are ___% lower than center engine N1
0.4%
-
Engine low pressure rotor speed ___ is the thrust setting parameter
N1
-
Takeoff and Max Continuous thrust must be based on ___ values given in the AFM, Section V, unless ___ is limiting
N1; ITT
-
Min O2 below 10,000' without passengers
650 psi
-
Min O2; 2 Crew with 10 or less pax to FL410
700 psi
-
Min O2 above FL410
Check Ops Manual
-
-
APU Max EGT Allowed
732 °C
-
APU Max Generator Load
300 Amp
-
-
APU Max Speed Allowed
110%
-
APU approved for ____ use only
Ground
-
APU bleed must be ___ for Engine of Airframe Anti-Ice checks
OFF
-
Discontinue APU Start (Stop pushbutton) if T5 does not rise within ___ seconds.
10
-
Wait ___ minutes before attempting a 2nd APU start
5
|
|