ASP/CSP Prep

• Boiling Point:
• Flash Point: Below 100F

• Boiling Point: Below 100 F
• Flash Point: Below 73 F

• Boiling Point: At or above 100 F
• Flash Point: Below 73 F

• Boiling Point:
• Flash Point: At or above 73 F and below 100 F

Flash Point: At or above 100 F and below 140 F

Flash Point: At or above 140F

Flash Point: At or above 140F and below 200 F

Flash Point: At or above 200 F

• Ceiling Temperature: 100 F
• Temperature Rating: 135 to 170 F
• Temperature Classification: Ordinary

• Ceiling Temperature: 150 F
• Temperature Rating: 175 to 225 F
• Temperature Classification: Intermidiate

• Ceiling Temperature: 225 F
• Temperature Rating: 250 to 300 F
• Temperature Classification: High

• Ceiling Temperature: 300 F
• Temperature Rating: 325 to 375 F
• Temperature Classification: Extra High

• Ceiling Temperature: 375 F
• Temperature Rating: 400 to 475 F
• Temperature Classification: Very Extra High

• Ceiling Temperature: 475 F
• Temperature Rating: 500 to 575 F
• Temperature Classification: Ultra High

This is equivalent to the old Class B. Class E helmets are proof tested at 20,000 volts.

This is equivalent to the old Class A. Class G helmets are proof tested at 2,200 volts.

This class provides no electrical insulation; the alpha designation did not change from the old standard.

• Gas, Vapor, Liquid
• Normal Conditions

• Gas, Vapor, Liquid
• Abnormal Conditions

• Dust
• Normal Conditions

• Dust
• Abnormal Conditions

• Fibers and Flyings
• Normal Conditions

• Fibers and Flyings
• Abnormal Conditions

An employee who is qualified to lock out machinery and perform maintenance.

An employee who normally works on or near a machine that must be locked out for maintenance.

A means of egress is a continuous and unobstructed way of exit travel from any point in a building or structure to a public way and consists of three separate and distinct parts: (a) the exit access, (b) the exit, and (c) the exit discharge.

is a particulate collection device that removes particles from a flowing gas (such as air) using the force of an induced electrostatic charge. Electrostatic precipitators are highly efficient filtration devices that minimally impede the flow of gases through the device, and can easily remove fine particulate matter such as dust and smoke from the air stream.[

a variety of devices that remove pollutants from a furnace flue gas or from other gas streams. In a wet scrubber, the polluted gas stream is brought into contact with the scrubbing liquid, by spraying it with the liquid, by forcing it through a pool of liquid, or by some other contact method, so as to remove the pollutants.

• Provide information needed to determine injury rates, id trends or problem areas, permit comparisions and satisfy workers comp requirements
• ID without placing blame the basic causal factors that contribute directly or indirectly to each accident
• ID deficiencies in management systems
• Suggest corrective actions for the incident
• Suggest corrective actions to the management system

25 lbs. per square foot applied uniformly over the entire span area

50 lbs. per square foot applied uniformly over the entire span area

75 lbs. per square foot applied uniformly over the entire span area

measure sound pressure level and are commonly used in noise pollution studies for the quantification of almost any noise, but especially for industrial, environmental and aircraft noise. However, the reading given by a sound level meter does not correlate well to human-perceived loudness; for this a loudness meter is needed.

a specialized sound level meter intended specifically to measure the noise exposure of a person integrated over a period of time; usually to comply with Health and Safety regulations such as the Occupational Safety and Health (OSHA) 29 CFR 1910.95 Occupational Noise Exposure Standard

• Metal underground water pipe
• Building steel
• Ufer Grounds (concrete encased)
• Ground rings